 | | | | Rubbermaid Antimicrobial Drain Boards |  | Brand: Rubbermaid
Category: Kitchen
Buy New: $6.50 - $17.67
Avg. Customer Rating:  (20 reviews)
Media: Kitchen
ASIN: B00144D170
Availability: Usually ships in 24 hours
|
| Customer Reviews: Read 15 more reviews...
 color June 30, 2008
Purchased this product to match the granite counter tops. Great color and good quality
 Drainboard June 18, 2008
It does what it's supposed to do; however, I'm not happy with the drain on the long end. It doesn't fit my sink well and is uncomfortable as it does not allow for the ergonomic placing of the dishes which should be left to right not front to back.
Drain Board April 14, 2008
1 out of 1 found this review helpful
I dissagree with most of the previous reviews. This drain board looks nice and functions perfectly. It cleans nicely, very sturdy and drains perfectly into the sink. I have had no problem with it slipping around. It does take up the counter width (front to back) but that gives you more room next to it. It is large enough to hold the Metro chromeplated steel dish rack which is a slightly larger size dish rack.
 Rubbermaid Large Drainboard January 27, 2008
3 out of 3 found this review helpful
The drainboard functions as advertised but I have have one negative comment on it. The underside verticle ribs, while slanted nicely to drain the water off, are made of a very hard material which causes the drain board to slide all over the countertop when even touched slightly. Dishes have to be placed in the top dish drainer carefully otherwise the bottom drain board slides out of position to drain the dripped water into the sink. The very thin underside vertical ribs make it almost impossible to stick on some type of anti slide rubber buttons to aliviate this sliding problem.
 Looks great but too slippery January 7, 2008
2 out of 2 found this review helpful
This is very nice looking and slanted so the water runs off. It has one drawback, it is much too slippery on the counter top. Needs to have some rubber grips attached to the bottom. I cut a non-slip piece of material to fit the bottom. Works great now.
|
|
|
Powered by Associate-O-Matic
| | |